Heli-max HMXE7459 Instrukcja Użytkownika Pobierz pdf

Heli-Max

™

AXE

™

CP CNC Bell Hiller Upgrade

PACKAGE CONTENTS

• Two CNC Bell Hiller blade grips with mixers pre-installed

• Two brass ﬂ ybar weights

• Four control rods

• Two short spacers

• Two long spacers

• Four plastic blade spacers

INTRODUCTION

The Heli-Max

™

AXE

™

CP Bell Hiller Uprade increases the control

rate and stability of your AXE CP drastically. The included adjustable

ﬂ ybar weights must be installed for initial test ﬂ ights. The ﬂ ybar

weights reduce the sensitivity of the control system. Please keep in

mind that even with the ﬂ ybar weights installed, the model will be 4 to

5 times more sensitive once you install the Bell Hiller blade grips.

Once you have become accustomed to the new Bell Hiller blade grips,

you will notice the model is much more responsive and accurate to

your control inputs. You will also notice the model can be ﬂ own in

stronger winds and fast forward ﬂ ight shows no instabilities.

If additional assistance is required for any reason contact Product

Support by e-mail at [email protected], by telephone at

(217) 398-8970, or visit www.helimax-rc.com.

INSTALLING THE UPGRADE

❏ 1. Remove the main blade bolts using a 1.5mm allen wrench.

Remove both main rotor blades from the helicopter. Remove the

2mm nut from the bottom of the blade grips. These will be needed

later when reinstalling main rotor blades.

❏ 2. Remove the oval linkages from the swashplate and ﬂ ybar

control arm.

❏ 3. Remove the spindle bolt using a 1.5mm allen wrench.

❏ 4. Remove the blade grip from the side you removed the spindle

screw from. Pull the other blade grip and spindle out of the head block.

❏ 5. Slide the spindle out of the blade grip and insert the spindle

into the new Bell Hiller blade grip. Slide a thin dampening spacer

onto the spindle.

1 2 3 4

Podsumowanie treści

Strona 1 - CP CNC Bell Hiller Upgrade

Heli-Max™ AXE™ CP CNC Bell Hiller UpgradePACKAGE CONTENTS• Two CNC Bell Hiller blade grips with mixers pre-installed• Two brass ﬂ ybar weights• Fou

Strona 2

2❏ 6. Using a 1.5mm allen key, push the new blade grip and spindle through the dampeners. Install the other thin dampening spacer onto the spindle as

Strona 3

3❏ 11. Slide one thin nylon washer onto the 2mm main blade screw. Slide the screw with washer through the blade grip and place one thin nylon washer o

Strona 4 - HMXE7459INST1

parallel to the ﬂ ybar, which is 0 degrees collective pitch. If the blades are not 0 degrees, then adjust the top linkage until they are. The linkages

Komentarze do niniejszej Instrukcji

Brak uwag

Heli-max HMXE7459 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Sprzęt powietrzny Heli-max HMXE7459. Heli-Max HMXE7459 User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt powietrzny Heli-max HMXE7459